FARGO DTC515 MANUAL PDF

FARGO Electronics DTC, DTC, DTC, DTC DTC color id printers, 10 Cleaning Cards, 10 Cleaning Pads, 10 cleaning tapes, full instructions. FARGO Electronics DTC, DTC, DTC, DTC DTC color id printers, DTC/ Dual hopper; PVC cards “); auto or manual feed. HID GLOBAL, HID, the HID logo, FARGO, and iCLASS, are .. installed and used in accordance with the instruction manual, may cause.

Author: Meshicage Vudogrel
Country: China
Language: English (Spanish)
Genre: Environment
Published (Last): 28 June 2006
Pages: 479
PDF File Size: 17.16 Mb
ePub File Size: 9.40 Mb
ISBN: 865-7-37597-176-3
Downloads: 86439
Price: Free* [*Free Regsitration Required]
Uploader: Grojinn

It can only be seen when you hold the Printhead, as shown here. Enter these values into the X and Y boxes. The Default settings for the Lamination Dwell Time and Temperature are preset for factory-recommended card stocks and overlaminate types.

FARGO Electronics DTC500 Series Troubleshooting Manual

Page 17 Switch Box or the peripheral. Replace the Main Print Board if problem still remains. Use this option to change the Printer’s internal settings for controlling the procedures in this section.

Enter these values into the X and Y boxes, as shown below. Compress the head springs Card Flipper onto the card path or into he Encoder.

Fargo DTC Thermal Printer Manual & User Guide – Fixya

Set the Printer on the lamination module’s Baseplate at an angle as shown. Be sure to push down on the cartridge until it clicks into place. Using The Image Position Button Use the Image Position controls to adjust the position of the overall print area to be precisely centered on a card.

  2052.DER NEUE BERICHT AN DEN CLUB OF ROME PDF

Replacing The Headlift Motor a Motor to the front side plate. Press Select to save the new value.

Selecting The Lamination Type If the Film Lamination option is selected, the film lamination is applied to the printed card, then the card nanual ejected. Select either the inches or mm radio button as needed. If the Motor turns, replace the Main Board as needed.

Page – Selecting the Defined Area s with the K The voltage should be greater than 4 VDC.

Lift the cover off of the Printer. As an alternative to replacing the Main Print Board, the chip U17 can be replaced. By pressing ‘print’ button you will print only current page. Page 45 – Resolving the Printer not reading Encode Select targo option to shift the recorded magnetic data to the left-hand side of the card’s Magnetic Stripe.

FARGO DTC SPECIFICATIONS Pdf Download.

Using The Disable Printing Option Step Procedure Select this option to ensure no print data will be sent to the Printer while all encoding instructions will be sent according to how they are configured within the fargoo. Resolving the excessive Resin Printing problems continued See the previous procedure in this section. Ensure that the guide belt for the Hopper Travel Assembly D is intact and moves smoothly.

  GELENKLAGER SKF PDF

Select this option to cause the Printer to dispense with the print job if a blank card is removed or ejected. This is the discharge end of the Printer. Replacing The Printhead Components Note: Extra Card Cleaning Cartridge fully assembled with tape for easy loading. Select Landscape to cause the card to print in a horizontal orientation, as shown on the below. Encoding Errors Determine if the Main Board dyc515 bad.

See the next page manaul a photo display. When this occurs, press the Cancel dttc515 key to manually eject the mistakenly verified card. Damage may occur to the lamination Roller! Release the plastic tabs in the four corners of the cover.

Installing The New Printhead Assembly However, the outline around the illustration will always remain in the same landscape orientation. Each Firmware type has a different update process.

The LCD will prompt: