Find the user manual and the help you need for the products you own at ManualsOnline. I got an old laptop model MA2 without powersupply. SetIP command to see and change the IP addresses of the console. This command can be used to change both Ethernet connectors and even set a gateway. Requirement: STP (shielded twisted pair) cable with RJ45 connector, min. Cat 5e . To connect Ethernet port 1: Connect one end of an Ethernet cable to the.

Author: Doumi Faugrel
Country: Costa Rica
Language: English (Spanish)
Genre: Relationship
Published (Last): 28 June 2006
Pages: 104
PDF File Size: 7.1 Mb
ePub File Size: 19.93 Mb
ISBN: 907-7-47968-493-8
Downloads: 27822
Price: Free* [*Free Regsitration Required]
Uploader: Gardajas

Your name or email address: Mayo Hardware Tue Mar 29, AC power plugged in, battery in, and the power button does nothing. This LED only lights up when your notebook is connected to AC power or the battery charge is very low.

Gateway Official Site: Worldwide

Sorry Mason, I have not gotten into any MA8 series yet. Hoosier Newman Wed Jan 22, If that ,a2 OK then you will need to check the AO see if it shorted.

This is a common problem with laptops. If not then look at the caps in the area.

Hi mayo I have a gateway ma3 and also no powe after close inspection i see the power gatweay marked pd33 is blown so I cant make the number on it to replace it. You will not even see anything.


Set the IP address in the console

I tried the other power supply and it doesn’t make a hum like mine. Mayo Hardware Thu Jul 26, Any help or information would be greatly appreciated John Sat Oct 23, So if they replaced the DC jack with a new one that would fix it?

Pulled battery, running kanual cord only. Neil Wed Jun 23, Then it is usually the AO Mosfet. Really no trick for testing the battery but most of the Gateway MA series batteries have a AO inside. Runs with charged battery of course Neil Thu Jun 24, My suggestion is have the tech redo the jack.

Then jumper it directly to the diode. Glad to hear you got your problem solved!!!! I have to come back to some problems even when I thought they were hopeless.

Thanks again for your help! I have shorted the Cmos Battery, any help would be nice, Thanks.

I should check that. StormJumperJul 23, On the bottom of the motherboard there are two identical chips marked AO side by side. After assuming it was the dc jack, i re soldered it, without success. gxteway

I can’t seem to figure out what is wrong with this gateway ma2 | NotebookReview

Im getting continuity at diode and ao oh the problem is my ma3 only works with the battery, it’s not charging or working from dcjack the dc jack was also replaced. I would like to know to where you jumped it? The easiest way is to bypass the shorted hole and jumper directly to the Diode. For this reason it is a good practice to keep the Art-Net in the “2” range.


I have used known good memory and it still reboots every 3 seconds with no video. Mayo Hardware Tue Jun 29, Recall of the original problem. Mayo Hardware Thu Jun 24, So I stay away from a drill or deburring tool.

It took a dozen wires to equal the diameter of a human hair. It looks like it marked P1 or P The Art-Net addresses have two ranges that are allowed – one starting with 2 and one starting with Thanks Sam I’ll take a look at a D and see what I can think of.

I can’t seem to figure out what is wrong with this gateway ma2

Check with another battery. Mayo Hardware Sat Aug 14, I would also like to know if I Could connect the power adapter directly to the motherboard’s pos and neg. A drop of flux will help the heat transfer and a drop of solder with a fine tip 40w iron.